Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
valentine's burning heart
14
Likes
175
Downloads
600
Views
Published on January 25, 2013
Derived from
Heart trophy
by cerberus333
Description
a small gift for valentine,
you only need a led candle to fit in
print it with white or translucid pla or ABS (white ABS work well) not transparent, the infill will be visible.
built in support for the reverse step under the base, will easily break off
built in reinforcement (with a small hole) at the back of the heart
you only need a led candle to fit in
print it with white or translucid pla or ABS (white ABS work well) not transparent, the infill will be visible.
built in support for the reverse step under the base, will easily break off
built in reinforcement (with a small hole) at the back of the heart
Instructions
print it 0.2 mm 2 perimeters, 0.1 honeycomb infill
open the candle move the led a few mm upward and sold it, to light the heart not the base
clip the bottom part of the candle (the one with the battery and led and switch) in the bottom of the base- may be you'll have to use a knife to fit it
and youre done with blinking light in the heart
a geek gift isn't it ?
open the candle move the led a few mm upward and sold it, to light the heart not the base
clip the bottom part of the candle (the one with the battery and led and switch) in the bottom of the base- may be you'll have to use a knife to fit it
and youre done with blinking light in the heart
a geek gift isn't it ?
License
valentine's burning heart by jfpion is licensed under the Attribution - Share Alike - Creative Commons license.
Nice - though I might need to adapt it for slightly different led candles which I have. They seem to have a thicker base that doesnt sit flush. Additionally I would recommend printing without infill and more perimeters if using a translucent PLA as the infil is quite visible when lit.