Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Rostock Rod Vibration Dampener / Stabilizer
10
Likes
157
Downloads
1188
Views
Published on January 26, 2013
Description
Just something I threw together for my Rostock printer to help keep any vibrations of the rods down. I am using carbon fiber rods that are about 5.5mm diameter. I picked up the springs at local hardware store. The printed pieces are about 21mm center to center so that leaves about a 33mm gap (with about 75mm distance between rods) for the spring. The springs I used were not too strong and about 20mm long.
Instructions
Print 6 pieces. Add a spring between each then snap onto the rods.
(Added second variation that would clip on at a different angle and have a less chance of pulling off).
(Added second variation that would clip on at a different angle and have a less chance of pulling off).
License
Rostock Rod Vibration Dampener / Stabilizer by jamesarm97 is licensed under the Attribution - Creative Commons license.
More from jamesarm97
More from 3D Printer Parts
You must be logged in to post a comment.