Case Fan Foot
0
Likes
56
Downloads
266
Views
Published on January 27, 2013
Description
This thing was made with Tinkercad. Edit it online tinkercad.com/things/cENdNp1uEa9
I use a case fan which has been spliced to an old cell phone charger to circulate air in my meat curing fridge. It works great. But the fan kept falling over.
I use a case fan which has been spliced to an old cell phone charger to circulate air in my meat curing fridge. It works great. But the fan kept falling over.
Instructions
Print 4 feet.
Holes for 6-32 screws/nuts, M3 should work too.
Will fit most any of the standard fan sizes and hold them upright while operating.
Holes for 6-32 screws/nuts, M3 should work too.
Will fit most any of the standard fan sizes and hold them upright while operating.
License
Case Fan Foot by lthomas987 is licensed under the Attribution - Share Alike - Creative Commons license.
More from lthomas987
More from DIY
You must be logged in to post a comment.