Arduino Case
28
Likes
452
Downloads
2032
Views
Published on October 18, 2010
Description
Case that holds an Arduino board, one shield, a 16x2 LCD and four AA batteries ( can be tight depending on battery holder chosen)
Instructions
Two are required to make one case. Its the same part repeated, it fastens to itself with #4 screws and PEMs.
There are also end plates, buttons and three backing plates required to finish it.
There are also end plates, buttons and three backing plates required to finish it.
You must be logged in to post a comment.
Anonymous
on
March 26, 2012
said:
Select inches. Let me know if you need some ref dimensions to check the scale before you print.
toatess
on
March 26, 2012
said:
I would like to upload and print this .STL file. Do I select mm, cm or inches for sizing?
mike_doell
on
October 18, 2010
said:
First rev of the Arduino housing in STL format. I will also post the accessories soon.
It consists of two identical parts.
License
Arduino Case by mike_doell is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from mike_doell
Is there any chance of getting the original CAD files for these parts? This case would be perfect for something I'm working on if the height was just a little bit more, and it's beyond a pain to modify STL files.