Customizable Spool Holder for Replicator 2
by woale, published
Adjustable by Spool Width and Spool Hole Diameter.
Need a Customizable Spool ? Go check out thingiverse.com/thing:45101
Recent Commentsview all
I made two, this thing works fine and save time when you get different spools from different providers. Thanks a lot to share.
I printed a couple versions of this spool holder to hold inexpensive PLA filament spools that have different dimensions than the MakerBot spools.
The result seems to work well, but I do have one suggestion.
I believe the design could be improved by doubling the height of the
bracket-end top-side spool shoulder
and adding a similarly sized
bracket-end bottom-side spool shoulder.
This would better control the position of inexpensive (and sometimes
slightly warped) filament spools.
Thank you for your time.
Liked Byview all
Give a Shout Out
You must be logged in to post a comment.