Arduino Uno Holder Tray
16
Likes
206
Downloads
1161
Views
Published on January 27, 2013
Description
This is a small, thin, very simple Arduino Uno R3 holder tray.
Instructions
Prints ok for me in Makerware on LOW with a Replicator 2. Prints for me in roughly 25 minutes.
License
Arduino Uno Holder Tray by mattkw80 is licensed under the Attribution - Share Alike - Creative Commons license.
More from mattkw80
More from Electronics
Thank you! I think the walls are too thin. (Too thin too drill anyway). Also, I want to get the holes into the bottom so the #4-40 bolts will secure it. I plan on making changes and reposting. If you have any suggestions, please let me know. Also note - I've been printing this on "low resolution" as it doesn't seem to require any higher resolution then that.