Yellow Submarine
59
Likes
576
Downloads
2941
Views
Published on January 28, 2013
This thing was Featured on January 28, 2013
Description
A model based on the yellow submarine
I have provided it in split for support-less printing, as well as full (needing support)
Not a perfect replica, but I am looking to make a small model.
Modeled in Sculptris
I have provided it in split for support-less printing, as well as full (needing support)
Not a perfect replica, but I am looking to make a small model.
Modeled in Sculptris
Instructions
Scale as desired, (small will hide my lazy modeling)
the split model will need to be glued together
Personally I prefer ABS for these situations, as ABS acetone glue-ups
work really well for me.
I have put both halves on the same build plate to allow scaling at one go.
my print was scaled down slightly split model
ABS
.15 slice
10% infill
80mm/sec
a few pinholes at these settings
glued with abs/acetone mix (syrup viscosity)
filled in holes by dabbing on the goop, set for 10 seconds
wipe off with a paper towel (repeat where needed)
the split model will need to be glued together
Personally I prefer ABS for these situations, as ABS acetone glue-ups
work really well for me.
I have put both halves on the same build plate to allow scaling at one go.
my print was scaled down slightly split model
ABS
.15 slice
10% infill
80mm/sec
a few pinholes at these settings
glued with abs/acetone mix (syrup viscosity)
filled in holes by dabbing on the goop, set for 10 seconds
wipe off with a paper towel (repeat where needed)
License
Yellow Submarine by cerberus333 is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from cerberus333
More from Vehicles
It must've been one of those unidentified flying cupcakes...
I've got a hole in my pocket
Ha, wow, haven't seen that movie in at least 10 years!