Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
2.5in Counter-rotating 3-blade spinner
2
Likes
192
Downloads
664
Views
Published on January 28, 2013
Derived from
2.5in 3-blade spinner
by odie_wan
Description
This is the counter-rotating version of my 2.5in 3 blade spinner (http://www.thingiverse.com/thing:44872). The negative offset base is unchanged from the normal rotating spinner. I uploaded it again for convenience.
It is designed for a 8" or 9" x 6-7" 3 bladed counter rotating prop.
It is designed for a 8" or 9" x 6-7" 3 bladed counter rotating prop.
Instructions
Version 1 of the base has an negative offset, meaning the bottom edge of the spinner will be "below" the prop adapter by .3125".
Version 2 has a normal offset of about .050".
The spinner cap is the same for both.
The cap and base are screwed together by M3x12-14mm socket head cap screws.
This should be pretty light, but I haven't had a chance to actually print this one out.
Version 2 has a normal offset of about .050".
The spinner cap is the same for both.
The cap and base are screwed together by M3x12-14mm socket head cap screws.
This should be pretty light, but I haven't had a chance to actually print this one out.
License
2.5in Counter-rotating 3-blade spinner by odie_wan is licensed under the Attribution - Share Alike - Creative Commons license.
More from odie_wan
More from R/C Vehicles
You must be logged in to post a comment.