Hey! This thing is still a Work in Progress. Files, instructions, and other stuff might change!
Improved frame vertex V2
by mrdummy, published
Use This Project
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.Print Thing Tag
After using new Y-carriage, i have new problems: the X-carriage belt bump against the rods. Now i have redesigned the frame vertex again to solve the problem. This is the result.
Not only the motor problem, but also the belt problem is happen in the printer even with first version frame vertex. That is because new Y-carriage is a bit higher and i lost the 100mm printing height. Not great.
Because the limited printing area, i tried to squeezed the whole design inside 190x190 area. Lucky, it fit almost inside. But you cannot use the skirt around the design. You better turn it off for such large print.
With this version 2, you should no have problems with X-carriage belt and you can go a bit higher. If you have low Y-carriage plate, you might have 110 or 120mm printing height.
In first picture, you see darkblue area. This is area where room is needed for the X-carriage belt. Of course the yellow rods are too large, it's just visual check.
I have not printed it out yet, but tomorrow i will print it out and use it on my printer to see if it's a success to make 100mm printheight. (it's now 94mm)
You need print it for both sides, thus 2 pieces. And you need to shorten all 4 rods for it.
Until now, it's in work in progress.
Upgrade this Thing with Thingiverse AppsCustomization
Edit, personalize, or revise this ThingPrint Fulfilment
Order a print of this ThingTools and Utilities
Repair, slice, or enhance this Thing
Improved frame vertex V2 by mrdummy is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving mrdummy a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure mrdummy would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).