Bre Do Major
by pmarxx, published
Recent Commentsview all
Thanks a lot, this is a really smart advice. Belive me or not, but I got my first printer today! It is Replicator2, I don't know if it is good or not yet.
I wish Bre doesn't feel offended that we discuss the length of his nose which may need some support at any angle:)
You could try to cut the bottom of Bre's bust in an angle, so the whole model is tilted a little backwards. This allows to print the nose without support.
I wish I knew how to make a face Makerbot printable. I am sure Breâ€™s nose would need a support, but other than this I have problems understanding 3D printing
The model is V-shaped. I was just thinking that most of the sculptures are supposed to be either standing or stuck to a wall or any surface. But why not to glue it to a
wall edge/ corner?
Give a Shout Out
You must be logged in to post a comment.