Hey! This thing is still a Work in Progress. Files, instructions, and other stuff might change!

Gauntlet Glove

by MKotsamanes, published

Gauntlet Glove by MKotsamanes Feb 1, 2013

Thing Info

20753Views 3188Downloads Found in Costume
Report Thing


Fully customizable printable Gauntlet/Glove for when you need to challenge someone to a duel.


Print the sizing guide measure your hand and make the adjustments. There is a not very hidden 'Easter Egg' in the assembly modes through customizer.
If you download the SCAD there are instructions on how to animate this glove also.
When creating your own select 'FullPrint' and what hand to generate a complete 1 print bed layout, this should fit on a Replicator at a full print bed but if you are using a smaller bed size there are options to generate the various parts. A word of warning when measuring your thumb, this is a complex set of parts and you may need the tweak and print a few times to get it comfortable.

More from Costume

view more

Thing Info

20753Views 3188Downloads Found in Costume
Report Thing


Liked By

View All


Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

this thing is awesome hard to print though you may need to modify it just grab tiny bolt or zip tys

Is there any way to extend the perimeters? My fingers are longer than this thing allows. lol

Also how to I determine the thumb bearing size?

I did my thumb bearing size at 7 and it was still a little big but i have small hands so you might want to do your at 8 or 9

when i print it i turn it so its flat on the bed and the extruder is to high so the filament doesn't stick,also what do you print it in and what angle do you print it in

I have an issue with the fingers - it's nearly impossible to wedge the fingers themselves into the knuckle joint

I've drilled holes in the knuckle joints and used nuts and bolts to secure them

has anyone tried to print this, and does it work well?

are the parameters in customizer in mm

Short answer, yes. Long answer is that it shouldn't matter as long as you scale appropriately before slicing.

Just like Tony Stark would have built in a Cave! (if he had a roll of plastic instead of a blowtorch)

a dual? is that like two fights? :)

Yeah, it's important to be prepared

Unfortunately I have a Prusa with extruder issues at the moment. I will hopefully have it up and running shortly and this on my list. There is now bridging in the print orientation and all angles are 45.

Have you tried printing and wearing this?

No but I wish