Photo Equipment Screws
by mechadense, published
one is 3mm unthreaded then 6mm threaded
the other is 25mm threaded
I made a test-print with a crazy outer layer height of 25 micron -yes- 0.025mm. The print worked but there was some waving reducing resolution and making the surface rough. Nevertheless it turned out very usable and especially sturdy against breakage through sideward bending.
Use the ancestor thing to generate alternate versions.
The commands to generate this two screws where:
hex_screw(25.41/4,25.4/20,30, 25,0.5,2,25.47/16-0.15,4,3, -1);
hex_screw(25.41/4,25.4/20,30, 6,0.5,2,25.47/16-0.15,4,0, 0);
Liked ByView All
Give a Shout Out
Photo Equipment Screws by mechadense is licensed under the Creative Commons - Public Domain Dedication license.
What does this mean?
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure mechadense would love to see what you've printed. Please document your print and share a Make with the community.