Galaxy Note 2 Otterbox Defender PS3 Controller Clip
by orias, published
Recent Commentsview all
The source file is simply the stl. I printed it in both PLA and ABS. I was able to print it with no modifications on several different printers. If you're encountering warping or splitting try covering your printer with a sheet/printing with a tall skirt/etc. I used a higher infill percentage than I normally use, 40% and printed with support.
I am having a hard time printing this successfully on a Printrbot LC. What tips or tricks do you recommend to print this successfully?
It started the wrong size, then I had to deal with warping, now I have to deal with layer splitting on the base. In addition to finagling Slic3r to position it right.
Can you share the source file?
Liked Byview all
Give a Shout Out
You must be logged in to post a comment.