8 Bit Heart Pendant Charm Set
by mortinus, published
Recent Commentsview all
The backs all share the same plane so if you rotate the entire model 90 degrees it will lay flat on the palte.
This is normally done in the print driver software such as replicator g, slic3r, etc.
It is lying flat in my model that was created, however Thingiverse's servers tweak the mesh data when I uploaded it, and they sometimes get "up" wrong.
Liked Byview all
Give a Shout Out
No support required!
My machine has a bit of a hard time getting EXACT holes, so I've increased the size to allow for a bit of room for the ball-chain.
You must be logged in to post a comment.