Mounting Bracket for Azteeg X3 and X1 and Sanguinololu for Prusa Mendel
3
Likes
130
Downloads
538
Views
Published on January 31, 2013
Description
This is a redesign of my Azteeg X1 bracket for the Azteeg X3. It mounts the board under the Y axis print bed. I had to lower the position of the board well below the y belt for clearance because the X3 board is wider than the X1. A version of the STL file for the X1 and Sanguinololu is also included.
Instructions
Print two, use a soldering iron to push M3 nuts into the cavities, push into the threaded rods and screw in the board.
License
Mounting Bracket for Azteeg X3 and X1 and Sanguinololu for Prusa Mendel by brnrd is licensed under the Attribution - Creative Commons license.
More from brnrd
More from 3D Printer Parts
You must be logged in to post a comment.