Dalek Salt & Pepper shakers
34
Likes
386
Downloads
1075
Views
Published on January 31, 2013
Description
Just what the Doctor ordered - with his chips (fries).
This prints out surprisingly well considering the overhang where the top fits onto the bottom. Both of these were my first prints and were printed with a layer height of .25mm and a fill of 25% with 2 perimeters and 2 tops/bottoms..
This prints out surprisingly well considering the overhang where the top fits onto the bottom. Both of these were my first prints and were printed with a layer height of .25mm and a fill of 25% with 2 perimeters and 2 tops/bottoms..
Instructions
Print them out.
Clean them out with a scalpal.
Drill out the small holes to 2mm diameter.
Dispense condoments :)
Clean them out with a scalpal.
Drill out the small holes to 2mm diameter.
Dispense condoments :)
Collections
Things to Make
by hod
Things to Make
by starky61
Movies, Video Games, Comic Books, TV Series, Internet stuff, etc
by Sushin
License
Dalek Salt & Pepper shakers by Wired1 is licensed under the Attribution - Non-Commercial - Share Alike license.
More from Wired1
More from Sculptures
I just printed out version 2 and it has some strange strings that I had to cut out near the opening. Here's a photo: http://i.imgur.com/q7Cfq3Z.jpg
Weird, I've printed out three of them now and mine only had a few light strands. Did you use Slic3r?