Sink Plug
2
Likes
64
Downloads
365
Views
Published on February 1, 2013
Description
Sink Plug to stop anything large from going down inside the garbage disposal without blocking water. Designed for an 85mm dia drain hole with a 15mm overlap
Instructions
I printed mine in PLA at 25% infill kisslicer works fine.
Not sure how it will handle full blast hot water from our on demand heater.
Not sure how it will handle full blast hot water from our on demand heater.
License
Sink Plug by Timelord83 is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from Timelord83
More from Kitchen & Dining
You must be logged in to post a comment.