NEMA17 Snapfit 40x40 Fan Mount for Prusa
by pauloblank, published
My steppers are getting too hot (~50Â°C), so I think is a good idea to install 40x40x10 fans in all of them. With that you get at least 5Â°C less.
First check if your NEMA17 stepper has recessions on corners in order the snapfits to be able to clip it.
The 40x40x10 fan I bought got 2.8mm holes, so I design the part for M2.5. Maybe you need to open the holes for M3.
YouÂ´ll need two M2.5x12 screws and two M2.5 nuts to mount.
I left enough clearance in the snapfit so youÂ´ll need a few finishing in your printed part.
ItÂ´s very light (3,2g) and prints in 26 min.
Liked ByView All
Give a Shout Out
NEMA17 Snapfit 40x40 Fan Mount for Prusa by pauloblank is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving pauloblank a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure pauloblank would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).