Wire Spool Clamp (Parametric)

by CodeCreations, published

Wire Spool Clamp (Parametric) by CodeCreations Feb 2, 2013

Thing Info

3983Views 401Downloads Found in Tools
Report Thing


This will help keep spooled wire in its place. Just pull it off to get to the wire, and snap it back in place when you're finished. There's a window so you can see what's underneath, and a little pull tab you can stick a label on.

Compatible with customizer, and fully parametric.


Choose some values in the "User-defined values" section if necessary, render, and print. The default values fit a typical wire spool found at Radio Shack.

More from Tools

view more

Thing Info

3983Views 401Downloads Found in Tools
Report Thing

Liked By

View All

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag


Bad photo.. but just saw two slots into the side of each spool, works a charm... little spacers on the spool holder stop them rubbing too.

if the open end looped around far enough couldn't you run the end out of the hole and just use it as a tension style spool?

Great idea! You can use customizer or OpenSCAD to change the size of the opening, spool diameter, and other parameters. Maybe I'll try to print one that wraps around further and see how it goes. Thanks for commenting!