Arcol.hu_hot-end_v3.0
17
Likes
1126
Downloads
723
Views
Published on October 30, 2010
This thing was Featured on October 30, 2010
Description
This is a dummy model of the Arcol.hu hot-end v3.0, because a hot-end can't be printed using plastic:)
You can print it to get a general feeling of the actual size. Also the mounting should be correct, so if you are working on your own machine, or new drive mechanism, you can adapt it easily by printing out this model.
The M3 bolt heads are commented out in the .scad file, to be printable.
I also added real photos for comparison.
You can read more about the hot-end itself at:
blog.arcol.hu/?p=1746
wiki.arcol.hu/arcol-hu-hot-end
You can print it to get a general feeling of the actual size. Also the mounting should be correct, so if you are working on your own machine, or new drive mechanism, you can adapt it easily by printing out this model.
The M3 bolt heads are commented out in the .scad file, to be printable.
I also added real photos for comparison.
You can read more about the hot-end itself at:
blog.arcol.hu/?p=1746
wiki.arcol.hu/arcol-hu-hot-end
Instructions
Print it, try it, adapt your machine.:)
License
Arcol.hu_hot-end_v3.0 by laszlo is licensed under the Attribution - Non-Commercial - Share Alike license.
More from laszlo
You must be logged in to post a comment.