Nintendo DS Game Card Box
14
Likes
201
Downloads
999
Views
Published on February 2, 2013
This thing can be customized with MakerBot Customizer!
Open in Customizer
Description
Box to Store Nintendo DS cards.
Use the customizer to set the number of Cards it can hold, 1 - 20.
Inspired by:
thingiverse.com/thing:44052
(was to big for my printrbot jr)
Nintendo Copyright and stuff.
Use the customizer to set the number of Cards it can hold, 1 - 20.
Inspired by:
thingiverse.com/thing:44052
(was to big for my printrbot jr)
Nintendo Copyright and stuff.
Instructions
1) Use the customizer to set the number of cards it can hold (1 - 20)
2) Customize some other settings if you like. (gutter, card spacing, box-roundness)
3) Print, PLA, 0.4 Layer Height, 0.4 infill (of maybe a bit less depending on your printer)
4) Add Nintendo DS Games
5) Put a Rubber Band around it, to prevent games falling out (see gutter on bottom)
6) ???
7) Profit !
Nintendo Copyright and stuff.
2) Customize some other settings if you like. (gutter, card spacing, box-roundness)
3) Print, PLA, 0.4 Layer Height, 0.4 infill (of maybe a bit less depending on your printer)
4) Add Nintendo DS Games
5) Put a Rubber Band around it, to prevent games falling out (see gutter on bottom)
6) ???
7) Profit !
Nintendo Copyright and stuff.
License
Nintendo DS Game Card Box by frankkienl is licensed under the Attribution - Share Alike - Creative Commons license.
More from frankkienl
More from Video Games
You must be logged in to post a comment.