ar.drone wall hanger
by dfb, published
Recent Commentsview all
Hi! I printed it the same was as in the preview picture, i.e. the part that will be touching the wall is the bottom of the print.
Lately I've been always printing with a raft, but that has more to do with me not calibrating the printer very well as opposed to anything specific to this model. There's a decent amount of surface are on the "bottom" of the print (the part that goes against the wall), so I imagine it'd print pretty well without a raft.
As far as supports go, I included some supports in the model - after printing I just cut them off with an x-acto knife.
I saw the picture you had of the finished product on your build platform.
I was just wondering if you had any recommendations for printing it (what orientaton, did you use raft / support structures, etc)?
Liked Byview all
Give a Shout Out
UPDATE (6 Oct 2013): someone asked me to upload the source (Blender) file I used to model it; hope someone finds it useful. I'm not an expert Blender user by any means, so apologies if it's sloppily done.
You must be logged in to post a comment.