Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Extruder Tray for Afinia/Up! Plus Printers
8
Likes
190
Downloads
1441
Views
Published on February 3, 2013
Description
Another version of the pen clip based extruder tray.
Take a look at thingiverse.com/thing:18010 for more info.
Take a look at thingiverse.com/thing:18010 for more info.
Instructions
requires a 5mm wide clip from a pen, a GC Switch (Part No 35-001) and the Octave Temperature Switch (or you can wire your own with a 12 ohm resistor).
The air hose clamps are attached with the screws on the side of the printer and holds the air hose in place.
The air hose clamps are attached with the screws on the side of the printer and holds the air hose in place.
You must be logged in to post a comment.
License
Extruder Tray for Afinia/Up! Plus Printers by walter is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from walter
More from 3D Printer Parts
Nice, thanks for uploading.