Action camera mount for RC Celica
by Cadvision, published
3D printable camera mount for Tamiya DF-03Ra Celica RC car. Tested with Liquid Image Ego action camera. Should fit also for GoPro.
Liked Byview all
Give a Shout Out
I printed the mounting plate with Dimension SST1200es and it fit perfectly. When attaching the plate on the car, first fix the front part of the body normally using the pin-clips and after that, lift the rear end of the body above the chassis pins and slide the mounting plate under the rear spoiler (note the U-groove on the mounting plate). Then lower down the body and mounting plate through the chassis pins and use the pin-clips to fix it.
I have a video on Youtube http://www.youtube.com/watch?v=czicHhEoDKo