Printrbot Fan Bracket - 60mm
7
Likes
111
Downloads
653
Views
Published on February 5, 2013
Description
A simple fan bracket I made for my Printrbot Jr.
It should fit into the slots of your extruder without the need to take everything apart or re-calibrating the z axis. I'll make different hole spacing if requested
It should fit into the slots of your extruder without the need to take everything apart or re-calibrating the z axis. I'll make different hole spacing if requested
Instructions
No instructions provided.
You must be logged in to post a comment.
adielfernandez
on
March 31, 2013
said:
Awesome idea and just what I needed! It printed beautifully but the spacing for the screws on the extruder are a little off. I have the wooden laser cut extruder but the plastic one and the screws are about 2-3 mm closer together than the mount. It was enough that I could just sand it down to fit it on but figured you should know.
Thanks!
dreadpyrate
on
February 20, 2013
said:
Thanks. I should too. I really wanted simple without the need to re calibrate anything.
pocketscience
on
February 20, 2013
said:
Nice one. Made one and it works a treat. Should probably print another as my first is a bit average as I didn't have a fan on it!
License
Printrbot Fan Bracket - 60mm by dreadpyrate is licensed under the Attribution - Share Alike - Creative Commons license.
More from 3D Printer Accessories
sure. send me the width of the fan you're using and the center to center measurement of the holes and I'll model it up.