CPAP headboard clamp
4
Likes
582
Downloads
540
Views
Published on February 5, 2013
Description
A swivelling clamp to attach the hose of a CPAP machine to the headboard of a bed.
Instructions
****A note to MakerBot, we need a health section in the categories
Print:
1 x Bed frame clamp (for headboard thickness of up to 30mm)
1 x Tube clip
1 x Pin (thigh for press fit or loose for hot glue)
2 x Screw (needs scaling, 1.08 worked for me, see notes bellow)
The screws work very well but you will need to scale them to fit your printer.
Save plastic, use the test screw.
Currently this clip fits a ResMed S9 H5i ClimateLine which is 19mm wide (so says Mr. Calliper)
If you would like me to adjust the clip for a different size let me know.
The clip should be able to stretch enough for a 22mm tube.
Print:
1 x Bed frame clamp (for headboard thickness of up to 30mm)
1 x Tube clip
1 x Pin (thigh for press fit or loose for hot glue)
2 x Screw (needs scaling, 1.08 worked for me, see notes bellow)
The screws work very well but you will need to scale them to fit your printer.
Save plastic, use the test screw.
Currently this clip fits a ResMed S9 H5i ClimateLine which is 19mm wide (so says Mr. Calliper)
If you would like me to adjust the clip for a different size let me know.
The clip should be able to stretch enough for a 22mm tube.
You must be logged in to post a comment.
License
CPAP headboard clamp by thecrazy is licensed under the Attribution - Non-Commercial - Share Alike license.
I second your motion for a "Health" category.