Invader
18
Likes
133
Downloads
654
Views
Published on February 5, 2013
Description
Invader from a classic tv show
Not a perfect replica.
a 3d printable version that does not require supports.
Not a perfect replica.
a 3d printable version that does not require supports.
Instructions
printed ABS
2 shells
10% infill
.27slice 80mm/sec
the dish antenna i felt would not print well.
just make a small one out of screen and a paperclip
if you feel the need for it.
Also this is a good candidate for 0% infill if you don't mind post fix-up on the top
and a few other spots. ( I havent printed it with 0% infill yet, but it looks like
it would go well with a few "holes")
2 shells
10% infill
.27slice 80mm/sec
the dish antenna i felt would not print well.
just make a small one out of screen and a paperclip
if you feel the need for it.
Also this is a good candidate for 0% infill if you don't mind post fix-up on the top
and a few other spots. ( I havent printed it with 0% infill yet, but it looks like
it would go well with a few "holes")
You must be logged in to post a comment.
License
Invader by cerberus333 is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from cerberus333
More from People
Nice print!
Thanks.
.27 looks decent in a bigger print.
I'm a sucker for Olde scifi stuff!