Raspberry Pi Case
12
Likes
829
Downloads
1812
Views
Published on February 5, 2013
Description
A base Raspberry Pi case created in OpenSCAD. Wanted a simple base that could be used to build up more complex cases.
The hole for the power cable is a little small so a standard phone charger isn't very tight.
The hole for the power cable is a little small so a standard phone charger isn't very tight.
Instructions
I printed this using the default medium setting in Makerware.
Infill: 10
Shells: 2
Layer Height: 0.27
No supports.
Infill: 10
Shells: 2
Layer Height: 0.27
No supports.
You must be logged in to post a comment.
License
Raspberry Pi Case by Lightshow74 is licensed under the Attribution - Share Alike - Creative Commons license.
More from Lightshow74
More from Electronics
thanks worked very well for me