Downloads

Sort By
Date
File Type
CarChassis.STL
462 kb / 152 downloads / 2 years ago
CarPlate2.STL
660 kb / 148 downloads / 2 years ago
There was a problem rendering this file.
BandCap.PRT
113 kb / 93 downloads / 2 years ago
There was a problem rendering this file.
RearWheel.PRT
129 kb / 96 downloads / 2 years ago
There was a problem rendering this file.
RearWheel.PRT
129 kb / 99 downloads / 2 years ago
There was a problem rendering this file.
FrontWheel.PRT
130 kb / 96 downloads / 2 years ago
There was a problem rendering this file.
Pulley.PRT
140 kb / 97 downloads / 2 years ago
There was a problem rendering this file.
CarChassis.PRT
272 kb / 96 downloads / 2 years ago

They Like It

James
deeeep
cymon
elspeth
Mike77
d_goodman
pattywac
obijuan
Erik
tc_fea
coasterman
atrophy
builttospec
NickAmes
schmarty
MaskedRetriever
JadeKnight
DaveD
clothbot
jkeegan
makerraf
MkMan
MTO
ssd
ZaphodBeeblebrox
Linkreincarnate
zignig

Instructions

Print two of CarChassis.STL and one of CarPlate2.STL. Clean the prints very well! Test fit and check tolerances to ensure wheels spin freely.

Using glue (I used hot glue) assemble the axles. The longer axles combine to form the front axle; the rear both slot into the pulley. Let the glue dry. Cut a rubber band and glue one end to the flatted part on the pulley. Place the other under the rubber band lock, apply a dab of glue, and tighten the tensioner.

If desired, glue on tread to the rear wheels. Combine to two halves of the body, and play!

Required Tools

Comments