GoPro Eggie camera mount
14
Likes
385
Downloads
1248
Views
Published on February 5, 2013
Description
a natural order version 2 GoPro camera mount, to remove vibration and jello effects.
version 1 needed more vertical stiffening, since it had too much flex and still vibrated.
after a bit of testing i came up with this evolved camera mount. its still not a final working item, once its fully functional i intend to add a camera facia plate to protect the gopro, maybe make it smaller and lighter and incorperate some other ideas i have. having said that, i thought i would upload thie version and allow others to make use of it or get their own ideas from it.
this mount is aimed at being used with my hcopter thingiverse.com/thing:32397
and
thingiverse.com/thing:32640
version 1 needed more vertical stiffening, since it had too much flex and still vibrated.
after a bit of testing i came up with this evolved camera mount. its still not a final working item, once its fully functional i intend to add a camera facia plate to protect the gopro, maybe make it smaller and lighter and incorperate some other ideas i have. having said that, i thought i would upload thie version and allow others to make use of it or get their own ideas from it.
this mount is aimed at being used with my hcopter thingiverse.com/thing:32397
and
thingiverse.com/thing:32640
Instructions
this mount is aimed at being used with my hcopter thingiverse.com/thing:32397
and
thingiverse.com/thing:32640
print %100, 0.2 height
assemble as per my youtube video - see links below
its based on m3x6mm approx screws
12mm m3 threaded hex spacers
O-rings about 17mm outside diameter
print the vert stiffener with support and with it orientated so the two flat ends
sit on the print bed.
parts needed and overview video similar to this here youtu.be/uZeyHgfuGms
build video similar to youtu.be/izoCp0qehYM
print out all the parts, glue the base / interface to whatever, also glue the top of the vertical stiffener, to the rear outer ring plate.
and
thingiverse.com/thing:32640
print %100, 0.2 height
assemble as per my youtube video - see links below
its based on m3x6mm approx screws
12mm m3 threaded hex spacers
O-rings about 17mm outside diameter
print the vert stiffener with support and with it orientated so the two flat ends
sit on the print bed.
parts needed and overview video similar to this here youtu.be/uZeyHgfuGms
build video similar to youtu.be/izoCp0qehYM
print out all the parts, glue the base / interface to whatever, also glue the top of the vertical stiffener, to the rear outer ring plate.
License
GoPro Eggie camera mount by intensewalkera is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from intensewalkera
More from Camera
You must be logged in to post a comment.