Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Braille labels
Description
A revised version of polymaker's openscad code. See kitwallace.posterous.com/printing-braille-label-via-openscad for discussion. The main improvement is autosizing the width of the label.
Instructions
I had trouble printing from this on a Makerbot - dots were indistinct and joined by many threads. It has been suggested that some software could produce G-code which created mulitple layers of a single dot rather than a single layer for every dot. I have yet to try this approach.
You must be logged in to post a comment.
License
Braille labels by kitwallace is licensed under the Attribution - Share Alike - Creative Commons license.
More from kitwallace
More from Signs & Logos
Works Very well, but found it prints best in the vertical position rather than lying flat.
Interesting - I was thinking of getting the slicer to build multple layers for each local tower to reduce threads and I did wonder about printing edge on - I'll add some footing for this approach.