Toyota Prius Wheel Center Cap - Pop Top
3
Likes
78
Downloads
616
Views
Published on February 7, 2013
Description
This thing was made with Tinkercad.
If you have a Generation III Prius (2010-present), you can pop off the UGLY wheel covers to release the alloy beasts underneath. Except - you'll have a hole in the center of the wheel that begs for a decorative cap. This is precisely measured from the Toyota part number 42603-52110 (pictured).
This has an aluminum soda can top design embossed in the top of the wheel center cap.
Also fits Yaris, Vios
I have other center cap designs available through Shapeways:
shapeways.com/shops/bitforge?section=Prius+Wheel+Center+Caps&s=0
If you have a Generation III Prius (2010-present), you can pop off the UGLY wheel covers to release the alloy beasts underneath. Except - you'll have a hole in the center of the wheel that begs for a decorative cap. This is precisely measured from the Toyota part number 42603-52110 (pictured).
This has an aluminum soda can top design embossed in the top of the wheel center cap.
Also fits Yaris, Vios
I have other center cap designs available through Shapeways:
shapeways.com/shops/bitforge?section=Prius+Wheel+Center+Caps&s=0
Instructions
No instructions provided.
You must be logged in to post a comment.
License
Toyota Prius Wheel Center Cap - Pop Top by schlem is licensed under the Attribution - Share Alike - Creative Commons license.
More from schlem
More from Automotive
cute