Plus Vase
41
Likes
400
Downloads
2007
Views
Published on February 7, 2013
Description
Another pretty object from a late night lofting session.
Shown printed in Taulman 618 on Garolite. Loving it.
Shown printed in Taulman 618 on Garolite. Loving it.
Instructions
Print hollow, no top layers.
You must be logged in to post a comment.
cerberus333
on
February 7, 2013
said:
Where did you get the Garolyte from?
how hard is it to remove the print from it?
BenitoSanduchi
on
February 8, 2013
said:
McMaster, like SystemsGuy said, though I couldn't find something similar on Amazon. :) It does take a little care to remove the prints. Seems like the best way to alleviate that problem a bit is taping off a portion of the base. See http://www.thingiverse.com/thi... . I just pry around the edges with a blade and haven't had any real problems. Don't squish the first layer down too much, not necessary.
License
Plus Vase by BenitoSanduchi is licensed under the Attribution - Non-Commercial - Share Alike license.
More from BenitoSanduchi
More from Decor
Another lovely vase, and great photos!