GoPro wrench
26
Likes
227
Downloads
1215
Views
Published on February 7, 2013
Description
This wrench is for adjusting the thumb-nuts on various GoPro mounting accessories.
I sometimes found I could not get enough torque on the thumb-nuts to secure my GoPro mounts to my satisfaction. This wrench was my solution.
I sometimes found I could not get enough torque on the thumb-nuts to secure my GoPro mounts to my satisfaction. This wrench was my solution.
Instructions
The wrench was printed on a RepRap Huxley in about 15 minutes using 2.2 meters of PLA with a solid fill.
I plan on tweaking my settings to get a better print but the wrench works fine as is.
I plan on tweaking my settings to get a better print but the wrench works fine as is.
License
GoPro wrench by engphysguy is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from engphysguy
More from Hand Tools
You must be logged in to post a comment.