igubal X carriage for prusa, mendelmax, etc.
by tmbg, published
I was quite unhappy with the LM8UU or bronze bearings that I had, and I really like the igubal plastic bearings, but there was no good way to use them on the x carriage. So we made one :)
Uses igus 8mm pillow block style bearings.
Bearings attach to the bottom, mounted upside down. Screw directly into the plastic bosses, no nuts required. I recommend using a washer under each screwhead.
Liked ByView All
Give a Shout Out
igubal X carriage for prusa, mendelmax, etc. by tmbg is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure tmbg would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).