Customizable Battery Tray
114
Likes
2092
Downloads
5009
Views
Published on February 10, 2013
This thing was Featured on February 11, 2013
This thing can be customized with MakerBot Customizer!
Open in Customizer
Description
Customizer for creating battery trays. Select the battery diameter, tray height, and quantity (works in clusters of four).
If you want a case to transport your batteries, take a look at the following battery cases:
thingiverse.com/thing:57281
thingiverse.com/thing:51376
If you want a case to transport your batteries, take a look at the following battery cases:
thingiverse.com/thing:57281
thingiverse.com/thing:51376
Instructions
If you want the corner radius to match the radius of the batteries, just set it to a large number.
You must be logged in to post a comment.
GregFisk25
on
March 4, 2013
said:
When I printed mine, there was no 'top' on the carrier. I can see the shells that make up the rounds, with no flat cover over them...
GregFisk25
on
March 4, 2013
said:
Any chance of making one of these where the bottom will attach to the top via friction? Would be the best, most customizable tray on here...
License
Customizable Battery Tray by walter is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from walter
More from Organization
The base appears to be too thin. Some of the batteries are a little bit hard to get in... love the concept
Press the "Open in Customizer" button above and you can easily set the base depth and battery diameter to whatever values you prefer.