GigaGremlin's Rubberband Gun
by GigaGremlin, published
And of course for my son :-))))
Recent Commentsview all
I know what you mean, well that is the tricky part.
You have to make sure that the wheel is in line and can not be pulled forward by the rubber bands. Otherwise you have to scrape off a pice of the Y Nose.
But of course you can also have weak spring used, hard to say...
Hmm, printed this and I cannot get it to work. The trigger assembly does not pull the sear far enough to disengage the band wheel.
Liked Byview all
Give a Shout Out
That Thing is almost complete printable, you just need a small Spring an two screws. I made the holes for a M3 screw tap.
The bolts are intentionally a little bit too long, cause you have to correct the upper/lower edge after printing and it's easier just shorten them. Sometimes you have to care about the edges of the holes to, depending on which PLA/ABS and/or Printer you use.
i hope you enjoy this Toy and publish many pics of your own copy.
Just by the way, the Chassis is about 6 hours and the other Parts are 3-4 hours printing time.
But it is worth it...
I've added the frame as individual files and even a new slightly larger med sitze Frame, also single Files for left & right.
You must be logged in to post a comment.