Ultimate S-Hook

by mike_linus, published

Ultimate S-Hook by mike_linus Feb 9, 2013

Thing Info

2821Views 857Downloads Found in Household Supplies
Report Thing


I was looking for an S Hook and was impressed with the original parameterised design. Unfortunately, I needed an S Hook that had a greater distance between the two hook ends. This design includes a length parameter which will automatically extend the S Hook if needed.


Using Open SCAD, change the required parameters to suit your needs and generate an STL file to print. The instructions are consistent with the original S Hook. Just modify the new length parameter. I used a default length of 60mm for my garage hook. Setting the length to 0 will produce the same results as the original design.

Using infill of around 12 % worked well for me when printing. Enjoy!

More from Household Supplies

view more

Thing Info

2821Views 857Downloads Found in Household Supplies
Report Thing


Liked By

View All


Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

All Apps

Customizer is the easiest way to take great 3D printable designs and make them your own. Make your OpenSCAD designs infinitely more valuable by empowering the community to customize them.

App Info Launch App
Customizer Thing App

This extension connects Thingiverse with Makeprintable, a cloud-based mesh repair service that analyzes, validates and repairs most common mesh errors that can occur when preparing a 3D design file...

App Info Launch App

To speed up "compile and render", change the for loop in the module cutOpening.
The change will reduce the number of steps taken to make the opening on the hooks.
This is done by changing the step angle from -1 to -$fa/2.
$fa is the sytem variable that holds the fragment angle used for approximation of circles and cylinders.
for(angle=[start:end]) {
for(angle=[start:-$fa/2:end]) {