Rostock J-Head Platform
29
Likes
604
Downloads
1747
Views
Published on February 9, 2013
Description
Rostock J-Head Platform with a nice mount, inspired by Drew's Mini-Rostock Platform.
Please note that like my other Rostock parts, this is for Traxxas ball ends.
Find the OpenSCAD sources on my github account. github.com/0xPIT/rostock
Please note that like my other Rostock parts, this is for Traxxas ball ends.
Find the OpenSCAD sources on my github account. github.com/0xPIT/rostock
Instructions
Print all three parts,
Tap M3 in each of the three skewed 'towers',
Tap M5 into top end for pneumatic fitting.
Clean Inside of top end for excess filament due to bridging,
sand/file down skirt & brim if you printed with.
Mount: Put holder into notch on J-Head, press top end on nozzle,
put nozzle in platform, tighten using three M3x16 screws.
Tap M3 in each of the three skewed 'towers',
Tap M5 into top end for pneumatic fitting.
Clean Inside of top end for excess filament due to bridging,
sand/file down skirt & brim if you printed with.
Mount: Put holder into notch on J-Head, press top end on nozzle,
put nozzle in platform, tighten using three M3x16 screws.
You must be logged in to post a comment.
License
Rostock J-Head Platform by 0xPIT is licensed under the Attribution - Non-Commercial - Share Alike license.
More from 0xPIT
More from 3D Printer Parts
hey there, do you have a foto with mounted cooling fans? or are you not using any?
hi. I'm currently not using cooling fans.