Minimal flush endstop mount for D4 microswitch
0
Likes
143
Downloads
339
Views
Published on February 9, 2013
Description
Yet another stupid endstop mount. This mounts a D4 microswitch directly against an 8mm smooth rod. About as minimal as you can get, I would think.
Instructions
Print out one for each microswitch, clip onto rods and attach switches using m3 screws/nuts.
Check that the switch will be correctly actuated by the axis before using them to home!
Check that the switch will be correctly actuated by the axis before using them to home!
License
Minimal flush endstop mount for D4 microswitch by mattproc is licensed under the Creative Commons - GNU GPL license.
More from mattproc
More from 3D Printer Parts
You must be logged in to post a comment.