Extruder Filament Guide
by rvcullen, published
I made an external filament guide to add to the top of a Greg's or other extruder for better guiding of the filament. I found that mine usually misses the guidler one and so I added this to the other side on top of the extruder housing. I like my Guidler to be back a little so the bolts will not pop off, so I needed this for a little extra help.
Print and secure on top of the extruder where the pocketed nuts are. I was not too worried about needing to replace the nuts anytime soon, so I just used a little acetone for glue and bonded it directly there. I used .33 layer ABS, nothing special. Only had to shve the notch a hair to get a nice sliding fit.
Liked ByView All
Give a Shout Out
Extruder Filament Guide by rvcullen is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving rvcullen a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure rvcullen would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).