Twist lock extrusion clip for 2020 extrusions
by rvcullen, published
Just the beginning of a quick idea for a T Clip substitute when you don't want to take things apart or buy the roll in type of tclips. Still needs a little tweaking, but overall a good working idea for a quick mount of fans,etc.
I printed this with a .35 nozzle and .25 layers. I didn't use support, but had to clean up the underside of the clip afterwards. Maybe support would be easier. I made the main hole a little small if you wanted to just use a screw in it, or you can use an M3 screw and a nut on the backside. Again, I made the nut area tight so it would hold the nut well, but still needs some fine tuning.
To install, just lock a nut underneath (or nothing if using a screw), place the tab into the extrusion, and turn 90 degrees while pressing in on the center a bit. It will lock in place when fully installed.
Liked ByView All
Give a Shout Out
Twist lock extrusion clip for 2020 extrusions by rvcullen is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving rvcullen a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure rvcullen would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).