Wall Mounted Holder for iPad With Cover
2
Likes
483
Downloads
489
Views
Published on February 10, 2013
Description
If your wife wants to mount her ipad on the wall by the treadmill to listen to Pandora, consider this 10-piece snap-together bracket/holder for an iPad with cover. It is meant to be wall mounted with two screws. The file here is not monogrammed like the one in the picture, in case your initials are not KLH. This is my first "thing" that I created from Sketchup to PrintrBot.
Instructions
Print one each of the following:
FrontMiddle
BackMiddle
LeftBack_L
RightBack_L
Print Two of:
Front_L
Print four of:
Stringer
Printing a brim seemed to reduce curling at the corners.
Snap pieces together. The pieces snap pretty firmly together, but I recommend super-gluing the joints. The three back pieces have stand-off to hold the piece off the wall 1/8 inch the allow clearance for the snaps.
FrontMiddle
BackMiddle
LeftBack_L
RightBack_L
Print Two of:
Front_L
Print four of:
Stringer
Printing a brim seemed to reduce curling at the corners.
Snap pieces together. The pieces snap pretty firmly together, but I recommend super-gluing the joints. The three back pieces have stand-off to hold the piece off the wall 1/8 inch the allow clearance for the snaps.
License
Wall Mounted Holder for iPad With Cover by Agger is licensed under the Attribution - Share Alike - Creative Commons license.
You must be logged in to post a comment.