Guardian of the temple
47
Likes
1109
Downloads
3135
Views
Published on February 10, 2013
This thing was Featured on February 11, 2013
Description
Elbereth, Princess guardian of the temple peaks, watching around from the top of the rock.
Instructions
this statue is 140mm height. you can print it supportless as i add support where needed inside the model.
remember to remove the two support pegs from her left arm (see picture).
the picture are from a print with 0.2mm ABS layer, sliced in Kissslicer with 2 perimeters and 0.42 skin wall
i also print her with success at 120mm height without problem.
remember to remove the two support pegs from her left arm (see picture).
the picture are from a print with 0.2mm ABS layer, sliced in Kissslicer with 2 perimeters and 0.42 skin wall
i also print her with success at 120mm height without problem.
License
Guardian of the temple by fantasygraph is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from fantasygraph
More from Sculptures
You must be logged in to post a comment.