by SmartFormat, published
Just print it!
I splitted it in two parts, so raft and supportless printing is possible. There are two small holes on the back, too. So glueing the parts together should be no problem
There is a download of the Gcode which should fit for Abs 1.75 mm with a layerheight of 0.2mm.
I printed it with my Solidoodle 2.
And as always: Show me your results or aks me questions if there are any :D
Liked ByView All
Give a Shout Out
Dragonhead by SmartFormat is licensed under the Creative Commons - Attribution - Share Alike license.
So what's this mean?
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure SmartFormat would love to see what you've printed - take a photo and share it on Thingiverse as a Make.