Osterizer Blender Base
by Roach, published
After one of my house mates broke the blender I decided to learn more about threading and draw up something in sketchup to replace it!
This is for the Osterizer 10 speed blender.
Recent Commentsview all
Liked Byview all
Give a Shout Out
There is a 1mm ring surrouding the inner hole to act as support material, so if your machine is okay with bridging, you should be able to print without support.
Sadly I messed up my scaling so I had to spend some time with the dremel trimming the 6 support struts on the outside to make it fit. I didn't update the drawing since I have a functioning base, but be warned that the 6 supports are about 1-2mm too large, but are easy to trim.