secondary amplifier mount - ultimaker
6
Likes
131
Downloads
515
Views
Published on February 11, 2013
Description
I wanted to cleanup the messy look that the top of my um head, since i added the second hot head and amplifier board. also i wanted to remove the temporary m4 nuts i was using to keep the long screws from getting in the way of the heater blocks.
Best results in a clear plastic, that way the led lights refract through.
Best results in a clear plastic, that way the led lights refract through.
Instructions
print.
i made the holes with a little less clearance so the screw would screw into the plastic.
i have added nut holes, in case someone wants to use longer screws to hold there amplifier boards in place.
Used cura:
Layer height: 0.2 Walls: 0.6 Fill: 20
Added the sketchup file in case anyone wants to modify the part.
i made the holes with a little less clearance so the screw would screw into the plastic.
i have added nut holes, in case someone wants to use longer screws to hold there amplifier boards in place.
Used cura:
Layer height: 0.2 Walls: 0.6 Fill: 20
Added the sketchup file in case anyone wants to modify the part.
License
secondary amplifier mount - ultimaker by kwatts is licensed under the Attribution - Share Alike - Creative Commons license.
More from kwatts
More from 3D Printer Parts
You must be logged in to post a comment.