Prusa filament spool holder by Phizinza
7
Likes
376
Downloads
986
Views
Published on February 11, 2013
Description
I saw JBFromOz's spool holder but wanted something a little different and designed this.
The arms click in simply, but it needs to be printed at an angle on the bed one arm at a time to fit. I had no trouble with warping on glass with ABS Juice.
The spool holder arms allow for 260mm diameter spools.
The spool spindles are designed to take spools with holes from 24 to 40mm diameter. They can be fitted with a standard 608 bearing (most commonly a skate bearing).
Hardware needed,
8mm threaded rod
A few 8mm nuts
Additionally: 2 x 608 bearings.
The arms click in simply, but it needs to be printed at an angle on the bed one arm at a time to fit. I had no trouble with warping on glass with ABS Juice.
The spool holder arms allow for 260mm diameter spools.
The spool spindles are designed to take spools with holes from 24 to 40mm diameter. They can be fitted with a standard 608 bearing (most commonly a skate bearing).
Hardware needed,
8mm threaded rod
A few 8mm nuts
Additionally: 2 x 608 bearings.
Instructions
Make sure you rotate the angle to print the arms. On a standard size bed 200x200mm I could only print one at a time.
You might need to press the bearings in, I just placed the spindles with the bearing partly in on the ground and trod on it.
Once printed, clip onto top rails and fit spindles and threaded rod.
You might need to press the bearings in, I just placed the spindles with the bearing partly in on the ground and trod on it.
Once printed, clip onto top rails and fit spindles and threaded rod.
License
Prusa filament spool holder by Phizinza by Phizinza is licensed under the Attribution - Share Alike - Creative Commons license.
More from Phizinza
More from 3D Printer Parts
You must be logged in to post a comment.