Makerbot replicator 20mm spool holder
3
Likes
148
Downloads
521
Views
Published on February 11, 2013
Description
spool holder for filament with 20mm diameter centres for Makerbot Replicator
This is a customized then altered version of thingi 44906 with a slight angle on the arm. Will fit reels up to 100mm wide.
This is a customized then altered version of thingi 44906 with a slight angle on the arm. Will fit reels up to 100mm wide.
Instructions
3 shells
10% fill
no support needed, left the arm off centre so it can be printed without support
10% fill
no support needed, left the arm off centre so it can be printed without support
You must be logged in to post a comment.
License
Makerbot replicator 20mm spool holder by lesley is licensed under the Attribution - Share Alike - Creative Commons license.
More from 3D Printer Accessories
I have to say that this is the best all-around spool holder for the Replicator. It fits everything, and it prints so cleanly.