Columbus's Egg
8
Likes
144
Downloads
1065
Views
Published on February 11, 2013
Description
This Egg Model stands on its tip.
en.wikipedia.org/wiki/Egg_of_Columbus
I took an egg and carefully cutted it into two pieces. Than I measured the height, the width and the Radiuses in order to be able to design this egg model.
Height: 57mm
Width (Diameter): 48mm
Yolk Diameter: 32mm
There are obviously endless variations.
Update: ColumbusEgg-V2
en.wikipedia.org/wiki/Egg_of_Columbus
I took an egg and carefully cutted it into two pieces. Than I measured the height, the width and the Radiuses in order to be able to design this egg model.
Height: 57mm
Width (Diameter): 48mm
Yolk Diameter: 32mm
There are obviously endless variations.
Update: ColumbusEgg-V2
Instructions
Slicer Settings:
layer height = 0.25
perimeters = 2
fill density = 0.1
perimeter speed = 50
nozzle diameter = 0.35
filament diameter = 1.75
brim width = 5
layer height = 0.25
perimeters = 2
fill density = 0.1
perimeter speed = 50
nozzle diameter = 0.35
filament diameter = 1.75
brim width = 5
License
Columbus's Egg by flurin is licensed under the Attribution - Share Alike - Creative Commons license.
More from flurin
More from Food & Drink
You must be logged in to post a comment.